compact passage GST

Description

  • Presence detector (PIR), with pre-configured cable and Wieland GSTi18 connector, cable length 1,50 meter
  • Mixed light measurement
  • Automatic control of lighting and HVAC as well as room monitoring function
  • Square detection area for corridors
  • Light switch output (relay, 230 V)
  • Presence switch output (relay, potential-free)
  • Choice of fully or semi automatic operation
  • Sensor or switch options for manual switching
  • The rectangular detection area covers an area of up to 30 metres in corridors and enables safe and simple planning
  • Fully or semi-automatic: In "Fully automatic" mode, the lighting switches on and off automatically according to presence and light. In "Semi-automatic" mode, it must be switched on manually and it switches off automatically
  • Manual override: The lighting can be manually switched on or off at any time via sensors or switches
  • Room/corridor sensor function: In the "corridor" setting, the detector functions as a staircase time switch and it cannot be switched off manually
  • Master/slave parallel switching: Up to ten detectors can be connected with each other to extend the detection area. The master switches the load. All other detectors merely provide presence information as slaves
  • Device can be connected as master or slave
  • Lighting control with light threshold value and self-learning switch-off delay
  • Pulse function for staircase time switch
  • HVAC control with switch-on and switch-off delay
  • Room monitoring with selective movement detection
  • The switching behaviour of the presence detector is controlled by presence and light
  • The self-learning switch-off adjusts to occupants' behaviour
  • The pulse function is for controlling a staircase time switch
  • The presence detector has a mixed light measurement and is suitable for switching the following types of lamp: Fluorescent lamps (FL/PL), halogen and incandescent lamps as well as LEDs
  • Presence switch contact for HVAC control: The switching behaviour of the potential-free contact is only controlled by presence
  • The switch-on delay prevents instantaneous switch on. The contact only closes on completion of the switch-on delay
  • Master/master parallel switching: Up to ten detectors can be connected with each other to control several lighting groups. Each master controls its lighting group according to its own brightness measurements. Presence is detected by all the detectors
  • The sensitivity of the presence switch output is reduced in the "monitoring" position. The contact indicates the presence of people with a high degree of certainty
  • Test operation mode checks the detection area and installation
  • The parameters can either be set using the potentiometer or via the optional service remote control SendoPro 868-A
  • A maximum of 10 detectors can be switched at the same time

Technical data

Operating voltage 230 V AC
Frequency 50 Hz
Recommended installation height 2聽鈥撀3,5 m
Installation type Ceiling installation
Power consumption ~0,7 W
Light measurement Mixed light measurement
Setting range brightness 10聽鈥撀1500 lx
Light switch-off delay聽 Impuls (0,5 s), 10 s-20 min
Type of contact light Relay 230 V
Lamps Incandescent/halogen lamps, fluorescent lamps, Energy saving lamps, LEDs
Resistive load 1400 VA
Incandescent/halogen lamp load 1200 W
Compact and flourescent lamps 960 VA (cos f = 0,8), 580 VA (cos f = 0,5)
Compact and flourescent lamps (Number of electronic ballasts) 10 x (1 x 58 W), 5 x (2 x 58 W), 16 x (1 x 36 W), 8 x (2 x 36 W), 16 x (smaller than 36 W)
LED lamp < 2 W = 25 W or > 2 W = 70 W
Switch-on delay presence 0 s聽鈥撀10 min
Presence switch-off delay 10 s-120 min
Type of contact presence Relay potential-free
Switching capacity presence 50 W (220 V DC), 50 VA (250 V AC) min. 0,5 mV/10 mA
Switching output Potential-free
Type of connection Screw terminals
Max. cable cross section 2 x 2,5 mm虏
Mounting plate 70 x 70 mm
Size of concealed housing 脴 55 mm (NIS, PMI)
Ambient temperature +0 掳C聽鈥β+50 掳C
Type of protection IP 40

Detection range

Mounting height (A) Head on to (r) Diagonally (t)
2 m 56 m虏 | 16 m x 3,5 m 卤 1,5 m 56 m虏 | 16 m x 3,5 m 卤 1,5 m
2,5 m 72 m虏 | 18 m x 4 m 卤 1,5 m 88 m虏 | 22 m x 4 m 卤 1,5 m
3 m 90 m虏 | 20 m x 4,5 m 卤 1,5 m 135 m虏 | 30 m x 4,5 m 卤 1,5 m
3,5 m 100 m虏 | 20 m x 5 m 卤 1,5 m 150 m虏 | 30 m x 5 m 卤 1,5 m
4 m 100 m虏 | 20 m x 5 m 卤 2 m 150 m虏 | 30 m x 5 m 卤 2 m
4,5 m 100 m虏 | 20 m x 5 m 卤 2 m 150 m虏 | 30 m x 5 m 卤 2 m
5 m 100 m虏 | 20 m x 5 m 卤 2,5 m 150 m虏 | 30 m x 5 m 卤 2,5 m
6 m 100 m虏 | 20 m x 5 m 卤 2,5 m 150 m虏 | 30 m x 5 m 卤 2,5 m
compact passage GST

Accessories

Article number Data sheet Documents basket
SendoPro 868-A - Infrared remote control for the convenient startup of HTS presence detectors

SendoPro 868-A

9070675
more
Ceiling installation box 73A - Ceiling installation unit for thePrema, theRonda, theMova P, PresenceLight 360, compact office,
                                 compact passage and compact passimo

Ceiling installation box 73A

9070917
more
QuickSafe - QuickSafe safety cover

QuickSafe

9070531
more
clic - Infrared remote control for ThebenHTS presence sensors

clic

9070515
more

Downloads

Format Download
Operating instructions PDF

Variants

Article number Data sheet Documents basket
compact passage WINSTA - Presence detector (PIR), with pre-configured cable and WAGO WINSTA Midi connector, cable length 1,50
                                       meter

compact passage WINSTA

2010105
more
compact passage - Presence detector (PIR)

compact passage

2010090
more
compact passage SR - Presence detector (PIR)

compact passage SR

2010807
more
compact passage BK - Presence detector (PIR)

compact passage BK

2010806
more
compact passage GST - Presence detector (PIR), with pre-configured cable and Wieland GSTi18 connector, cable length 1,50 meter

compact passage GST

  • White
Article number 2010100
Data sheet
Documents basket